China Moneypro Precision Centrifugal Testing Component

Main Technical Specifications

1. Acceleration range: ±0.5g to ±70g.

2. Acceleration measurement uncertainty:

   • Within (0.5g to 1g) range: 5×10⁻⁵ g (k=1)

   • Within (1g to 70g) range: 5×10⁻⁵ (k=1)

3. Rotational speed requirements

   • Speed range: 20 to 340 r/min

   • Speed measurement uncertainty: 2×10⁻⁵ (k=1)

   • Speed setting resolution: 2×10⁻⁴ r/min

   • Speed stability: <2×10⁻⁵ (1-minute average)

   • Speed repeatability: <1.5×10⁻⁶

4. Turntable surface and radius requirements

   • Table diameter: 0.9 m

   • Working radius: approximately 0.45 m

5. Azimuth angle of the mounting reference surface for the high-performance quartz inertial device

   • The settable azimuth angle shall be at least 0° or 180° to allow calibration of the high-performance quartz inertial device in both positive and negative acceleration directions.

   • Azimuth misalignment angle: θ ≤ 3′

6. Pitch misalignment angle of the mounting reference surface for the high-performance quartz inertial device: θ ≤ 10″

7. Angle between the main spindle rotation centerline and the vertical line: θ ≤ 20″

8. Slip ring requirements

   • Number of rings: 20 rings (using two wires combined)

   • Dynamic contact resistance variation: <0.05 Ω

   • Insulation resistance: 300 MΩ / 500 VDC

   • Operating current: 1 A

9. Load capacity

   • The centrifuge has a load capacity of 15 kg (including fixtures).

10. Fixtures

    • Used for mounting the high-performance quartz inertial device under test; four devices can be installed at one time.

11. Self-diagnostic function

    • The equipment shall have a self-diagnostic function.

12. Operating mode: Automatic mode. Speed control, dynamic radius measurement, and output measurement of the high-performance quartz inertial device are performed by a computer according to operator commands.

13. Safety requirements

    • Since the centrifuge is a large rotating equipment, safety protection design shall be implemented against various possible unexpected situations.

14. Equipment reliability

    • The equipment shall be capable of continuous operation for 8 hours under normal conditions for calibrating high-performance quartz inertial devices.

    • MTBF of the equipment > 2000 hours.